SiriusXM Radio UTV Antenna
Model # UTVANT
Flush / Roof Mount Assembly
1.
Select the location to install your antenna allowing for maximum clearance.
2.
Use the hardware shown in diagram A for this assembly type.
3.
Drill a hole in the surface area of the desired mounting area.
4.
Place the L bracket over the hole and secure the L bracket to the roof with the supplied mounting
screw, rubber, washer and lock nut as shown in Diagram D.
5.
Be sure to place the rubber cap on the end of the screw.
Pipe Mount Antenna Assembly
1.
Select the location on the roll cage to install your antenna allowing for maximum clearance.
2.
Use the hardware shown in Diagram A for this assembly type.
3.
Insert the screw shown in Diagram B into one of the rubber washers and slide it through the hole
on the L bracket. Next slide the second rubber washer onto the screw.
4.
Insert the screw through the L bracket and then slide the second rubber washer over the screw.
This will help to reduce vibration.
5.
Slide the screw through the hole on the other end of the clamp as shown in Diagram C.
6.
Screw the lock nut on the screw and tighten the screw securely.
7.
Apply the supplied locking solution to the screw and nuts as needed to secure the nut to the screw.
8.
Be sure to place the rubber cap on the end of the screw.
Diagram B
Pixel Technologies, Inc. | 800.595.0845 | www.pixelsatradio.com | [email protected] | Page 2
Diagram A
Diagram C
Installed
Installed
Installation Instructions
Diagram A
