PIVOT CORPORATION
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 Japan TEL0263-46-5901
1
2
3
1
0
ø56.5
ø56.5
ø56.5
ø52
ø52
38
6
Troubleshooting
Basic operation from engine start to stopping.
Basic Operation
1
2
3
4
5
Trouble
Possible Causes
Possible Solutions
Opening
Demo
Current RPM display
Meter OFF
The Opening Demo does not work.
Opening Demo works but the needle
does not work with Engine start.
The car ’s tachometer and PT5-X
reading are very different.
The auto-power window function and/or
other electronic devices are re-set.
R e - c o n n e c t t h e m i n u s t e r m i n a l a n d fo l l ow
re-setting instructions for any affected devices.
See [Connection for Cylinder Number Setting] on
Page 3 and make sure to connect as directed for
the number of cylinders.
See [Connection for Cylinder Number Setting] on
Page 3 and make sure to connect as directed for
the number of cylinders.
This is due to the minus terminal on the battery
being disconnected.
The Connection for Cylinder Number Setting is
incorrect.
The cylinder setting is wrong.
Poor connection or wrong wiring of each cable.
Poor connection of
White
wire.
Engine
START
Note: Due to characteristics of
the gauge, even though the
engine is off and the gauge is
not measuring, the needle will
not return to “0”.
Note: During no
idling, the needle
will display “0”.
• Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
• We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar
designs, regulating characteristics, circuitry and circuitry layout.
• We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User’s Manual.
Please reconfirm whether wiring and connections
are correct or not.
Please reconfirm whether wiring and connections
are correct or not.
(Note)
Install in an easy-to-view location.
Fastening The Product
Meter dimensions
(unit: mm)
A. Installation with the Adjustable Stand
Slightly loosen the screw and install
the gauge into the Band Holder.
Fasten using the double-sided tape. (Clean
the surface; removing all oil and dust.)
After deciding the position and angle
of the meter face, fasten the hexago-
nal bolts on both sides to secure.
Band Holder
Hexagonal bolt
Hexagonal bolt
Clean to remove
oil and dust
Double-sided
tape (Included)
Fasten using the double-sided tape. (On top of the steering column cover or dashboard.)
Note: It is possible to install the Adjustable
Stand in the reverse direction.
Wrap the cushion tape around the base of
the meter.
Note: Please be sure about where you wish
to install the meter, as it is not advisable to
reuse double-sided tape.
B. Mount into the Panel
Panel
(Reverse direction)
(Normal)
Cushion tape
1
Press into the 52 mm hole in the panel.
2
Turn the
ignition to the
OFF position
(Engine stop)
