8
PIVOT CORPORATION
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 JAPAN
0
1
8
6
2
Troubleshooting
If connect the power cable to IGN
(The installing car model mentioned in the Compatibility List)
IGN Cable
＝
Cut Connector
IGN
(12V with key ON)
OBD Cable
Diagnostic
Monitoring
Connector
Yellow
Yellow
Red
How to use the Cut Connectors
1
10
mm
2
10
mm
3
4
5
Trouble
Possible Causes
Possible Solutions
Poor connection of each Cable or Con-
nector.
The unit has been installed into an
incompatible car model.
Wrong Communication-system has set.
Reconfirm whether wiring and connec-
tions are correct or not.
Check the “Compatibility List”.
Check the ”Setting Communication
system”.(See page 4 of this manual)
Set communication-system to C.
Self-Adjusting Brightness
【
Check the Luminance
】
(Normally not necessary)
【
Connecting
】
The battery goes flat
on the car
which needs to be set communication-
system C. (Prius ZVW50, etc.)
The communication-system has set
something other than C.
It will return to the normal brightness in
a few minutes when the temperature
in-car dropped.
The display is dark
when the
temperature in-car is high on start-up.
T h e b r i g h t n e s s h a s au to m at i c a l l y
adjusted by safety function of the prod-
uct.
The engine has been turned OFF
but the display remain on.
Press the
DOWN switch
during
Single-display
for 3 seconds
1
Real-time display
Display
Luminance
3
2
Release the switch
and no operation
for 5 seconds
Daytime (bright)
Nighttime (dark)
Luminance (%)
Ambient
brightness
Under 50
From 50 to 60
Over 60
Luminance (%)
Ambient
temperature (°C)
100%
75%
60%
20%
100
100
75
60
20
When crimping, please
use crimpers or use pliers
to bend and then solder
together.
Peel off of the vinyl
cover at connection.
Peel of f of the vinyl
c ove r at t h e e n d o f
the product’ s wire.
Wrap around both
wire coils.
Close tightly with
cut connector.
Insulate with vinyl
tape.
Change the wiring to IGN, if the installing car
model mentioned in the Compatibility list or the
display does not lit with engine start sometimes.
Unplug the connector of
Red
and
Yellow
cable of
OBD Cable and connect the connector of
Yellow
cable to IGN.
Brightness of the display is automatically adjusted under the following conditions.
●
Adjustment according to ambient brightness
(reduce nighttime glare)
●
Adjustment according to ambient temperature
(prevent the product deterioration)
This product is interlocked with the ECU (engine computer) power. Depending on
the model of car, the display may remain on for up to 3 minutes even after the
engine has been turned off; this is normal.
Does not display with Engine
start.
• Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
• We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar
designs, regulating characteristics, circuitry and circuitry layout.
• We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User’ s Manual.
(Note)
