4
PIVOT CORPORATION
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 JAPAN
START
START
ENGINE
STOP
STOP
START
ENGINE
STOP
Troubleshooting
Basic Operation
1
4
2
3
5
Meters do not work.
Connecting each Cable and the Unit and Installing
4
Connect Gauge Cable and OBD Cable to the Unit
Connect to the Unit.
●
Gauge Cable
Connect to
1-pin connector
of OBD Cable.
●
Fuse Power Cable
●
OBD Cable
Connect to the Unit.
Notes about using the OBD Connector
Make sure to grip the
distended por tions
when pulling it out or
inserting it.
In such case, pull
out the connector
by pulling on the
end of the zip tie.
W i t h s o m e c a r m o d e l s i t
m ay b e d i f f i c u l t t o g e t a
good grip on the connector.
Do not pull on the wires
when trying to remove the
connector; the wires may
become disconnected.
1
10
mm
2
10
mm
3
4
W h e n c r i m p i n g, p l e a s e
use crimpers or use pliers
to bend and then solder
together.
5
※
The 3-pin connectors can
be connected to any of the
three positions
Zip tie
(Large)
Fastening to Flat Space
When Fastenings to
a Cable or Pipe
Installing the Unit
Fasten the unit into positions not usually affected by water.
Unit
Double-sided
tape(square)
(Included)
Through
holes
Thick cable
or pipe
Clean to
remove
oil and dust.
How to use the Cut Connectors
Peel off of the vinyl
cover at connection.
Peel off of the vinyl
cover at the end of
the product’ s wire.
Wrap around both wire
coils.
Close tightly with cut
connector.
Insulate with vinyl
tape.
Real-time display
Meter OFF
Key Switch OFF
(Engine stop)
Key Switch ON
(Engine start)
Opening Demo
(Start-up all together)
Trouble
Possible Causes
Possible Solutions
Please check the “Fitting List” .
Poor connection of
Gauge Cable
,
OBD Connector
and
Fuse Power Cable
.
Poor connection or wrong wiring of
Red
cable if wired directly to the power supply.
Please reconfirm whether wiring and connec-
tions of
Gauge Cable
,
OBD Connector
and
Fuse Power Cable
are correct or not.
Depending on the altitude, needle shifts about one scale by the characteristics of car side
sensor(absolute pressure), but this is not a malfunction.
Needle of the boost gauge is shifted
to slightly negative from 0 than the
others(relative pressure).
Please reconfirm whether wiring and connec-
tions of
Red
cable is correct or not.
The unit has been installed into an incom-
patible car model.
If you unable to get a grip
on the distended portions.
※
Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
※
We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar designs,
regulating characteristics, circuitry and circuitry layout.
※
We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User’ s Manual.
