Piusi PW Mobile, Инструкция по установке и эксплуатации

Страница: 35 / 64

35
/124 35
/64
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
translated from italian
PW Mobile
2 DECLARATION CE OF CONFORMITY
The undersigned: PIUSI S.p.A
Via Pacinotti 16/A z.i. Rangavino
46029 Suzzara - (MN) - Italy
HEREBY STATES under its own responsibility, that the equipment described below:
Description : PW Mobile MODULE
Model : PW Mobile
Serial number: refer to Lot Number shown on CE plate affixed to product
Year of manufacture: refer to the year of production shown on the CE plate affixed to the product
is in conformity with the legal provisions indicated in the directives:
- Electromagnetic Compatibility Directive 2014/30/EU
- Low-Voltage Directive 2014/35/EU
- RED Directive 2014/53/EU
The documentation is at the disposal of the competent authority following motivated request at Piusi
S.p.A. or following request sent to the email address:
doc_tec@piusi.com. The person authorised to compile the technical file and draw up the declaration
is Otto Varini as legal representative.
Suzzara 13/06/2017 Otto Varini
legal representative
3 MACHINE AND MANUFACTURER IDENTIFICATION
FOREWORD
PW Mobile has a single externally applied product identification plate
bearing the following information:
- Manufacturer details - Serial number of internal router
- Model - CE marking
- lot number - Production year;
ATTENTION Before installing, always make sure the type of dispensing system is cor-
rect and suitable for the available power supply (Voltage/Frequency.)
Make sure that the plate does not deteriorate or become detached over
time.
NOTE Should this situation arise, please contact our support department and
arrange to have the damaged or missing plates sent back and replaced
where necessary.
THE PLATES ARE THE FOLLOWING: