Page 4
For technical questions, please call 1-888-866-5797.
Item 69814
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Symbols and Specific Safety instructions
Symbol Definitions
Symbol
property or statement
pSi
Pounds per square inch of pressure
cFM
Cubic Feet per Minute flow
ScFM
Cubic Feet per Minute flow
at standard conditions
npt
National pipe thread, tapered
Symbol
property or statement
npS
National pipe thread, straight
WARNING marking
concerning Risk of Eye Injury.
Wear ANSI-approved eye protection.
WARNING marking concerning
Risk of Explosion.
Specific Safety instructions
1. Use as intended only. Do not
use for any other liquid.
2. Vehicle must be safely supported by a
proper vehicle lift before service.
3. Use on flat, hard, level surface only.
4. Do not use near open flame or heat
sources. Do not smoke during use.
5. Prior to using the Drain, read and understand all
warnings, safety precautions, and instructions
as outlined in the vehicle manufacturer’s and
the support device’s instruction manuals.
6. Do not use the Drain with the
vehicle’s engine running.
7. Keep bystanders away during use.
8. Avoid burns. Allow the engine oil to completely
cool before draining the oil into the Drain.
9. Do not leave unattended when
operating or evacuating oil.
10. Remove the Drain before lowering the vehicle.
11. Recycle used oil according to regulations.
12. Install an in-line shutoff valve to allow
immediate control over the air supply in an
emergency, even if a hose is ruptured.
13.
Do not exceed the product’s
working pressure of 10 pSi.
14. Wear heavy-duty work gloves during use.
15. If used oil does not evacuate the Tank upon
pressurization, close the Ball Valve fully with the
handle in the horizontal position.
If this does not correct the problem,
remove the unit from service immediately and
contact a qualified service technician for repair.
16. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
SaVE tHESE inStructiOnS.
