Page 3
For technical questions, please call 1-888-866-5797.
Item 64982
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual before set up or use of this product.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly
1. Thread the Puller Sleeve (6) onto
the Puller Unit about halfway up the
threaded section of the Puller Unit.
2. Determine if the best grip on the part to be
pulled is from the outside or the inside. The
hooks on the Jaws (1) face inward when
gripping the part from the outside. They face
outward when gripping the part from the inside.
3. The Jaws have four different settings
(two holes and then flip over the Jaws for the
other two settings). Each can be for both
inside and outside pulling. Determine whether
to use the upper or lower holes in the Jaws
and which way the Jaws should be turned.
WARNING! Turn all the Jaws the
same way to ensure even pulling.
4. Assemble each of the three Jaws
onto the Puller Sleeve (6) using two
Connector Plates (5) and two sets of
Bolt (19) and Nut (20) as shown.
5. Insert the Handle (11) into the
Pump Handle Socket (12).
Connector
Plate (5)
Jaw
(1)
Puller Sleeve
(6)
Handle
(11)
Pump Handle
Socket (12)
Nut (20),
Bolt (19)
Functions
The tool is designed to pull items such as
bearings, pulleys, and chucks from shafts.
The Jaws (1) can grip the object from the
inside or outside, whichever offers a better grip.
The Piston (2) will push on the central shaft while
the Jaws pull away. This will remove the item from
the shaft by pulling it straight out evenly, without
hammering or binding from pulling at an angle.
