Page 3
For technical questions, please call 1-888-866-5797.
60234
Setup
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Remove load from the jack before any procedure on this page.
Note:
For additional information regarding the parts listed in the following pages,
refer to
Parts List and Diagram
on page 7.
Assembly
1. Connect a Support (41) to each corner of the
Saddle (32) using a Bolt (39) and Washer (40).
2. Thread a Wing Nut (37) onto the threaded end of
the Chain Hook (38) with its wings facing the hook.
3. Slide a Washer (31) onto the threaded
end of the Chain Hook.
4. Insert the threaded end of the Chain Hook through
the hole on the bracket on the Saddle, as shown.
5. Secure the Chain Hook to the Saddle’s bracket
using Washer (31) and Wing Nut (37).
Bolt (39)
Washer (40)
Support (41)
Saddle
(32)
Wing
Nut (37)
Wing
Nut (37)
Chain
Hook (38)
Washer (31)
Washer (31)
Figure A: Assembly
Checking/Filling Hydraulic Fluid
IMPORTANT! Before first use:
1. Remove the Oil Fill Plug.
2. Check hydraulic oil level and fill to 1/4"
below the fill port as needed.
3. Replace the Oil Fill Plug.
4. Thoroughly test the Jack for proper operation.
If it does not work properly, bleed air from its
hydraulic system as described in Bleeding, below.
Release
Valve
Oil Fill
Plug
Handle
Figure B: Hydraulic Fluid Service Parts
Bleeding
1. Follow the Checking/Filling Hydraulic Fluid
instructions above.
2. Turn the Release Valve counterclockwise to open it.
3. Pump the Handle up and down quickly several
times to purge air from the system.
4. Check hydraulic oil level and fill to
1/4" below the fill port as needed.
5. Replace the Oil Fill Plug and close the
Release Valve by turning it clockwise.
