15
GVC355SM-001PI_v01
16
EPA inlet filter (installed in the CYKLON dust container)
17
Foam inlet filter (installed in the CYKLON dust container,
in the frame of the EPA outlet filter)
18
CYKLON dust container (a removable part of the vacuum
cleaner)
19
Tube of the CYKLON dust container (installed in the
CYKLON dust container)
20
Switch-over nozzle brush
21
Crevice nozzle
22
Small brush
23
Small nozzle
24
Turbobrush
Before first use
B
1
Put the end of the suction hose to the inlet of the vacuum
cleaner. A characteristic “click” signalizes the hose has been
properly installed.
2
Connect the other end of the hose with the telescopic
suction pipe.
3
Select the needed length of the telescopic suction pipe
by sliding the slider according to the arrow, and pulling out/in
the pipe.
4
Install a nozzle or a brush on the other end of the suction
pipe.
5
Use combination carpet & floor brush for vacuuming both
hard surfaces and carpets. To clean hard surfaces – wooden
floors, plastic floors, ceramic tiles etc. pull out the brush by
pressing the switch on the combination brush according
to the figure
. Retract the brush when vacuuming
carpets (set the switch in “
”).
6
Grab the plug of the cord
(3)
, and pull it out of the
vacuum cleaner.
When pulling out the cord pay attention to
the yellow band which marks the end of the
cord. Any attempts to unwind the cord further
(especially forcefully pulling on it) may lead to
damaging it.
7
Put the plug of the cord in an electric socket.
Before turning the vacuum cleaner on, make sure the
CYKLON dust container is installed in the chamber of the
vacuum cleaner, and also the inlet filters and the outlet filter
are installed in the vacuum cleaner.
8
Press the on/off button to start the vacuum cleaner
(4)
.
9
The vacuum cleaner is equipped with an electronic
controller of suction power, which enables smooth regulation
of suction power of the vacuum cleaner. By moving the slider
(5)
left and right you may respectively increase or decrease
the suction power.
10
The vacuum cleaner is also equipped with a mechanic
suction power controller
(11)
, which is situated on the hose
handle. You may use it to slightly regulate the suction power
without the need to use the slider
(5)
.
Technical parameters
The type of the vacuum cleaner and the technical parameters
are indicated on the rating label. Mains protection 16 A. Does
not cause interferences with audio/video devices.
Does not require grounding
.
Vacuum cleaners meet the requirements of the applicable
norms.
The appliance is in conformity with the requirements of the
directives:
–
Electrical equipment designed for use within specific
voltage limits (LVD) – 2006/95/EC.
–
Electromagnetic compatibility (EMC) – 2004/108/EC.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing the Directive
of the European Parliament and of the Council 2009/125/EC
with regard to eco-design requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament and of
the Council 2010/30/EU with regard to energy labelling of
vacuum cleaners.
Noise level: 81 dB(A).
The appliance was marked by a CE sign on the rating label.
Static electricity
In the process of vacuuming of some surfaces in areas of
low air humidity the device may become electrically charged.
It is a natural phenomenon – it does not damage the device,
and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend you to:
●
discharge the device by touching metal items in the room
with the pipe,
●
increase air humidity in the room,
●
use widely available antistatic agents.
Design
A
1
Outlet filter cover
2
Fastening of the nozzle brush or the telescopic pipe
3
Plug with the cord
4
ON/OFF button
5
Suction power regulation slider
6
CYKLON dust container fill indicator
7
Cord winder button
8
CYKLON dust container unlocking button
9
Handgrip for carrying the vacuum cleaner
10
Handgrip for carrying the CYKLON dust container
11
Bolt – a mechanic controller of suction power
12
Suction hose
13
Telescopic pipe with a fastening hook
14
Outlet foam filter (installed in the vacuum cleaner)
15
Frame of the outlet filter (installed in the vacuum cleaner)
