2. Take one axle and push a rear wheel onto one end. Push
the other end through the axle bushings at the back of the
dragster. Place the other rear wheel on this end of the axle.
3. Take the other axle and push a front wheel onto one end. Push
the other end through the axle bushings at the front of the
dragster (Figure 7). Place the other front wheel on this end of
the axle.
Operating Your Kit
1. Place a four- or eight-gram CO
2
cartridge in the rear of the
dragster (Figure 8). Make sure the cartridge is all the way in
and fits snugly.
2. Run the car on the track as you would race any dragster on
your racing system.
Figure 7
A completed EZ Build Dragster.
Figure 8
EZ Build Dragster Kit User Guide 33104 V0812
