Pitsco Education SunZoon Lite, Руководство пользователя

Страница: 4 / 8

4 SunZoon Light User Guide 59022 V0513
6. One at a time, carefully push the screw eyes where the 1/4"
marks cross the axle lines. Taking care to keep them straight,
twist them into the board. Make sure the flat side of the
screw eye is perpendicular to the axle lines.
7. If you want to put paint or another finish on the chassis
board, do so now. If you paint the underside of the chassis
(the side with the screw eyes), do not get paint in the screw
eye holes.
8. From the gear font, detach Gear I (40-tooth, 1/8" bore). This
is the drive gear. There may be some burrs – called flashing
– on the gear, which will keep the gear from running
smoothly. With the hobby knife, trim off any flashing.
9. With the scissors, cut four 1/4" pieces of the plastic tubing.
These will be used as spacers on the axles.
10. Start an axle into the hole on one of the rear wheels.
Caution: If it is difficult to push in, you can hold the wheel
and, with the opposite end of the axle against a solid
surface, push down on the wheel to push in the axle. The
axle should not extend past the other side of the wheel.
11. Push the drive gear on the axle end and push it until it is
snug against the wheel. Add a spacer against the gear. Hold
the car so the bottom of the chassis board is facing up and
the back end is toward you. From the left side, push the end
of the axle through the two screw eyes that are on the back
axle line (Figure 2 on the next page). When you flip the car
over, the wheel and gear will be on the right side.
12. Place another spacer on the end of the axle. Push the other
rear wheel on the axle (Figure 2). For the wheels to turn
properly, make sure the wheel and axle parts are not pushed
together too tightly.