SDC965B DL400 Operator Guide
Contents
Removal/Replacement & Adjustments
Upper Transport Cover Replacement
Safety
Follow the normal safety precautions for all office equipment:
• Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper
storage and use of aerosol dusters or flammable aerosol dusters can cause an
explosive-like condition that could result in personal injury and/or property damage.
Never use aerosol dusters labelled flammable and always read instructions and safety
precautions on the duster label.
• To obtain supplies, please contact our Supply Line
TM
to place orders. Material Safety
Data Sheets can be obtained on the web or from our Supply Line
TM
. Refer to the
Contact Information List for more information.
• Use the power cord supplied with the machine and plug it into a properly grounded
wall outlet that is located near the machine and is easily accessible. Failure to properly
ground the machine can result in severe personal injury and/or fire.
• Avoid touching moving parts or materials while the machine is in use. Keep hands,
loose clothing, jewellery and long hair away from all moving parts.
• Do not remove covers or defeat safety interlock switches. Covers enclose hazardous
parts that should only be accessed by properly trained service personnel. Immediately
report to service any damaged or non-functioning components that renders the unit
unsafe.
• Place the unit in an accessible location to allow for proper venting of the equipment and
to facilitate servicing.
• The power cord wall plug is the primary means of disconnecting the machine from the
AC supply.
• Do not use an adapter plug on the line cord or wall outlet.
• Do not remove the ground pin from the line cord.
• Avoid using wall outlets that are controlled by wall switches, or shared with other
equipment.
• Do not route the power cord over sharp edges or trap between furniture.
• Ensure there is no strain on the power cord and that it does not become jammed
between the equipment, walls or furniture.
• Be certain the area in front of the wall receptacle into which the machine is plugged is
free from obstruction.
• Before clearing a stoppage, be sure machine mechanisms come to a stop.
• When removing stalled material, avoid using too much force to protect against minor
personal injury and damaging equipment.
• To prevent overheating, do not cover any vent openings.
• Operation of this equipment without periodic maintenance will inhibit optimum operating
performance and could cause the equipment to malfunction. Contact your machine
supplier for required service schedule.
• Read all instructions before attempting to operate the equipment.
• Use this equipment only for its intended purpose.
• Always follow the specific occupational safety and health standards for your workplace.
Safety
EN
Click on any of the subjects in the contents list to jump
straight to that section.
