Pitco L20-299, Инструкция по установке и эксплуатации

Страница: 2 / 20

L20-299 Rev. 0 6/06
TO THE PURCHASER
Post in a prominent location the instructions
to be followed in the event that an operator
smells gas. Obtain this information from
your local gas supplier.
WARNING
There is an open flame inside this appliance.
The unit may get hot enough to set nearby
materials on fire. Keep the area around the
appliance free from combustibles.
WARNING
DO NOT
supply the appliance with a gas
that is not indicated on the data plate. If you
need to convert the appliance to another
type of fuel, contact your dealer.
WARNING
DO NOT
use an open flame to check for
gas leaks!
WARNING
If gas flow to appliance is interrupted, or pilots
extinguish, wait 5 minutes before attempting to
relight the pilot to allow any residual gas in
appliance to dissipate.
WARNING
Ensure that the appliance can get enough air to
keep the flame burning correctly. If the flame is
starved for air, it can give off a dangerous carbon
monoxide gas. Carbon monoxide is a clear
odorless gas that can cause suffocation.
WARNING
Adequate means must be provided to limit the
movement of this appliance without depending on
the gas line connection. Single appliances
equipped with legs must be stabilized by installing
anchor straps. All appliances equipped with
casters must be stabilized by installing restraining
chains. If a flexible gas line is used, an additional
restraining cable must be connected at all times
when the appliance is in use.
WARNING
An appliance equipped with casters and a flexible
gas line must be connected to the gas supply with
a quick disconnect device. This quick disconnect
must comply with ANSI Z24.41. To limit the
movement of the appliance without depending on
the connector or quick disconnect, a restraining
cable must also be installed.
WARNING
Models with electric controls are equipped with a
shortening/oil proof electrical supply cord, with a
three prong safety plug. This is to protect
operators from electrical shock hazard in the event
of an equipment malfunction. DO NOT cut or
remove the grounding (third) prong from this plug.
WARNING
This appliance, when installed, must be electrically
grounded in accordance with local codes, or in the
absence of local codes, with the
National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.2,
as applicable.
WARNING
The power supply must be disconnected before
servicing or cleaning this appliance.
WARNING
Do not attempt to move this appliance when the
unit is at operating temperature or filled with hot
shortening/oil. Serious personal injury could result
if skin comes in contact with the hot surfaces or
shortening/oil.
WARNING
DO NOT sit or stand on this appliance. Serious
injury could result from falling or contact with hot
shortening/oil.
FOR YOUR SAFETY
DO NOT store or use gasoline or other flammable vapors or liquids in the
vicinity of this or any other appliance.
WARNING
Improper installation, alteration, service or maintenance can cause property
damage, injury or death. Read the installation, operating and maintenance
instructions thoroughly before installing or servicing this equipment.