Pit Boss 10558, Руководство по сборке и эксплуатации

Страница: 11 / 24

11
INSTALLING A GAS CYLINDER
1. Make sure burner control knob is turned
OFF by pushing it in and turning it
clockwise to the OFF position.
2. While holding carrying handle closest to
propane cylinder with one hand, push
propane cylinder into regulator and turn
clockwise until tight.
3. For optimum performance, allow
cylinder to hang vertically off the edge
of the table or sits stable on a table
(clean, level surface) where there is no
danger of being bumped or disturbed.
Note proper positioning shown.
WARNING: Do not transport griddle with gas cylinder attached. The
cylinder may loosen off the valve, and cause a gas leak, possibly
resulting in an explosion, fire, or severe bodily harm. Disconnect
gas cylinder first before travel or storage.
The outdoor grill, when installed, must be electrically grounded in accordance with local
codes or, in the absence of local codes with the National Electrical Code ANSI/NFPA 70,
or Canadian Electrical Code, CSA C22.1.
1. Do not store a spare LP gas tank under or near this appliance.
2. Never fill the tank beyond 80 percent full.
3. If the information in 1) and 2) is not followed exactly a fire causing death or
serious injury may occur.
DISCONNECTING A GAS CYLINDER
1. Ensure the control knob on the griddle is completely closed by turning to the OFF
position. Turn LP gas tank valve to the CLOSED position, and allow the regulator
knob to pop out.
2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator
valve opening. Replace the protective caps on the regulator valve opening and the
top of the gas cylinder for storage (if not empty).
NOTE: If storing the griddle indoors, leave the gas cylinder outdoors.
Tighten the
connection
between
pressure
reducing valve
and gas
cylinder