the
DF
position disables the low battery notification. Default is set to
CH
.
This feature only support model GS07, GS08 and PS03.
Program the Motion Sensor
1. Before programming any sensor, you need to switch off all your existing sensors
and disarm your system.
2. Press
PROGRAM
button on console and enter the default password
888 888
Use
Scroll key
to choose
Sensor
then press
Enter
on Console. Choose
Add
and press
Enter
again. Then you will see
Trigger Sensor
.
Trigger your sensor by walking 2-3 steps in front of The Motion Sensor which you have
prepared and you will see nine digits displayed on console screen for 1-2 seconds. This
is the unique address for this sensor. The Console will request you add a Zone Name
for this sensor, then press SAVE. You will see
Record Sensor Name*
.
*Hint1: Recording a name is optional. You can record a voice for this sensor. You will
hear this voice when the alarm goes off and it is easy for you find which sensor has
been triggered. You can do it later in
Edit
which is under the
Sensors
menu. For more
information about Edit, please read Hint3*.
NOTE: Each time you select
Add
following the above steps, you can add from one up
to 50 sensors. After programming all sensors to your console, please test each sensor
before you mount the sensor in the appropriate location.
Test the Motion Sensor
The Motion Sensor is in Walk Test mode during the first 3 minutes after the front cover
is re-attached. During walk test mode, the LED blinks when motion is detected and then
waits 60 seconds before resuming motion detection. During normal operation, the LED
will remain on for 3 seconds when motion is detected until the Motion Sensor blinks
once again before resuming motion detection for next detector.
1. Move away from the area that is in direct line of sight of the Motion Sensor (move
to an adjacent room). Wait 60 seconds until the LED stops blinking.
2. Move back into the line of sight of the Motion Sensor, walk around 3-5 steps.
(this will trigger the main console).
If the Motion Sensor test is successful the LCD screen will display " xxx Sensor Alarm".
If these words do not appear, either (A) the 20-second waiting period since the last
trigger has not expired, or (B) the Motion Sensor is not in communication with the
PiSECTOR system main console.
