Pirexx PX-1, Руководство по эксплуатации, установке и обслуживанию

Страница: 13 / 21

24
25
DECORATION
The smoke alarm devices test/stop
button (Fig. 1d) is removable (Fig. 3)
and can be decorated to match the
design of the room. Please decorate
exclusively this removable surface of
the device and never any of its other
areas. Afterwards, please refasten it to
the device.
Caution! The smoke intake fins (Fig.
1c) on the side of the device must
always be kept clear of obstruction
and may never be blocked!
The identification plate of the device
is found under this easily removable
cover.
Please protect this device, especially
during renovation but also generally,
against wetness, cold, heat, fine dust,
vapors with oil, nicotine or paint as
well as paint supplies such as wall paint,
adhesives and all kinds of dirt. During
renovation, construction or sanding, the
smoke alarm device may be removed
from the magnetic holder (Fig. 1b) by
lifting it lightly upwards and then stored
safely.
After finishing the work, it is vitally
important to remember to place the
smoke alarm device back on the mag-
netic holder (Fig. 1b).
Please always observe the following:
Only when the device is located at
its intended installation site, unsoiled,
undamaged and activated is it able to
perform its potentially life-saving task of
signaling alarm.
INTENDED USE
Use this device exclusively for the pur-
pose it was designed and built for! Any
other application is not as intended!
This device may only be used for the
following purpose(s):
• Detection of fire or smoke in private
households
• This smoke alarm device comes with
heat warning functionality. It is how-
ever not a heat detector according to
EN 54-5.
The installation and use of this device
in habitable recreation vehicles (e.g.
travel trailers) has not been tested.
SERVICE LIFE OF THE DEVICE
After 12 years at most, the end of the
service life of the device will have been
reached. Please replace the device.
CE CONFORMITY
This product has been tested and
certified according to the directive
89/ 106 EEC under the terms of
EN14604:2005/ AC:2008 as a building
product. Production is monitored by
regular and independent inspections of
consistent compliance with legal and
regulatory requirements.
SERVICE
The PX-1 is produced by
PX Technologies GmbH.
pyrexx.com/en/support
en en