Page
6
of
15
6
Assembly
A small amount of assembly is required when you receive your steam mop.
•
First, remove all the components from the packaging.
•
Connect the handle by placing it over the top of the telescopic tube (upper
end) and then slide down until it clips into place. You may need to push
the spring pin (on the telescopic tube) inward a little to allow the handle to
slide over. Ensure the pin locates in the hole in the side of the handle
when pushed down. Ref fig 1-A
•
Insert the lower end (smaller diameter) of Telescopic Tube into the yoke
on top of the Mop Head. When inserting, make sure the spring pin (on
the telescopic tube) faces towards the back side of the yoke as illustrated
Ref fig 1-B.
Push the Telescopic Tube down into the yoke until the spring pin snaps
into the small hole in the back side of the yoke Ref fig 1-C. The
Telescopic Tube should now be secured to the MOP Head.
NOTE
: In order to coax the spring pin in to the hole, it may be necessary
to rotate and adjust the Telescopic Tube until it aligns properly with the
hole.
