Piranha C62109, Руководство пользователя

Страница: 5 / 16

Insert the screw so it passes through the handle into the vacuum.
Begin to tighten the screw with your fingers.
It may be necessary to adjust the handle slightly.
Using a screwdriver lighten the screw.
CAUTION
Do not over tighten.
Over tightening could strip the screw holes.
Do not operate the cleaner without the screw in place.
CORD ASSEMBLY
Make sure the quick release cord hook is in an upright position.
Remove the wire tie from the power cord.
Lock the cord into place by forcing it into the locking notch on the body of the
vacuum.
This helps keep the power cord out from under the vacuum cleaner agitator.
Wrap the power cord around the quick release cord hook and the lower cord
retainer.
ATTACHMENT ASSEMBLY
After the handle has been assembled to the body and the power cord has
been wrapped around the cord hooks, the attachments can be added.
1. Snap the end of the hose into the wand, place this wand in the right slot of
the tool holder.
2. Place the other wand in the rear slot of the tool holder and slide the
crevice tool into this wand.
3. Place dusting brush into the brush clip.