Page 11 of 16
10 Safety Devices Operation
NOTE
: The motor has an overheating protection device built in.
It will automatically switch off power to the motor if it overheats. e.g. from
blocked nozzles, full dust Canister or uncleaned blocked filters.
If this happens, turn off the vacuum and unplug from power socket, clean
blockage and / or filters and allow to rest for at least 60 minutes which should
be enough time for the motor to cool down.
Important
: If the over-temperature device activates and turns the motor off,
and you do not switch off and unplug the appliance from the power point, the
motor will restart automatically after it has cooled down enough to reset the
safety device.
NOTE: NEVER BLOCK ANY VENTS OR OPENINGS.
11 Emptying the Dust Canister
Empty the Dust Canister as frequently as possible or when the suction power
is reduced.
•
To remove the Dust Canister, turn off the power and unplug.
•
Grip the handle on the Dust Canister, press the
Dust Canister Release Button and pull the Dust
Canister forward and out of the housing.
•
Take the dust container to a dustbin.
•
Press the Trap Door release button on the lower
part and the trap door will open emptying the
contents into the bin.
•
To close the trap door, close it manually until it
clips shut.
•
Brush the inside of the dust canister with a small brush or wash
Refer to section “Cleaning Filters”.
•
To refit the Dust Canister in to the vacuum cleaner, simply align the
dust canister into its position and push down until it locks in place.
