Piper PA-32R-301T SARATOGA S, Руководство по обслуживанию

Страница: 43 / 956

A. Scheduled Maintenance (continued)
4. Periodic Inspection (continued)
—
NOTE —
Refer to Notes 1, 2, 3, and 4 before performing inspections.
PIPER AIRCRAFT
PA-32R-301/301T
MAINTENANCE MANUAL
5-20-00
Page 5-13
Reissued: July 1, 1993
1C18
NATURE OF INSPECTION
E. FUSELAGE AND EMPENNAGE GROUP (cont)
3. Inspect battery, box, and cables. Inspect at least every 30 days. Flush box as
required and fill battery per instructions on box. ..........................................................
4. Inspect electronic installations ......................................................................................
5. Inspect bulkheads and stringers for damage .................................................................
6. Inspect antenna mounts and electric wiring..................................................................
7. Inspect hydraulic pump motor brushes (see note 18)....................................................
8. Check hydraulic pump fluid level. Fill as required.......................................................
9. Inspect hydraulic pump lines for damage and leaks. (Refer to latest revision of Piper
Service Bulletin No. 616.).............................................................................................
10.Inspect for obstructions and contamination in inlet of backup landing gear extender
actuator inlet head .........................................................................................................
11. Inspect air conditioning system for freon leaks ............................................................
12.Inspect freon level in sight gauge of receiver-dehydrator (see chapter 21) ..................
13.Inspect air conditioner condenser air scoop rigging .....................................................
14.Inspect fuel lines, valves, and gauges for damage and operation .................................
15.Remove, drain, and clean fuel strainer bowl and screen located in bottom of selector
valve. Drain and clean at least every 90 days ...............................................................
16.Inspect security of all lines............................................................................................
17.Inspect vertical fin and rudder surfaces for damage .....................................................
18.Inspect rudder hinges, sector and attachments for damage, security, and operation.....
19.Inspect vertical fin attachments for security .................................................................
20.Inspect rudder control stops to ensure stops have not loosened and locknuts
are tight..........................................................................................................................
21.Inspect rudder hinge bolts for excess wear. Replace as required..................................
22.Inspect stabilator surfaces for damage ..........................................................................
23.Inspect stabilator tab hinges, horn, and attachments for damage, security, and
operation........................................................................................................................
24.Inspect stabilator attachments for corrosion, rust, and security.(See note 26.).............
25.Inspect stabilator and tab hinge bolts and bearings for excess wear. Replace as
required. (See note 26.) .................................................................................................
50 100 500 1000
O O O O
O O O
O O O
O O O
O O O
O O O O
O O O
O O O O
O O O
O O O O
O O O O
O O O
O O O O
O O O
O O O
O O O
O O O
O O O
O O O
O O O
O O O
O O O
O O O
Inspection time (hrs)