XV-GX3
79
5
6
7
8
5
6
7
8
C
D
F
A
B
E
7.1.10 DISASSEMBLY
1
Remove 11 screws from Bonnet.
2
2 7
Press the
STANDBY/ON button to turn on the power.
3
Press the
0
OPEN/CLOSE button to open the Tray.
4
Remove the Tray Panel.
5
Set the Test Disc.
Bonnet and Tray panel
1
How to open the Tray when the power cannot be on
Insert a Tweezer(as shown in the photo) into the Slit located at
the bottom of the unit and slide the projection of the Drive Cam in
the Loader Assy in the direction of the arrow, as indicated in the
photo.
If the Tray pops out a little, fully pull it out by hand.
Diagnosis of PCB's
Note 1:
Do NOT look directly into the pickup lens. The laser beam may cause eye injury.
Note 2:
Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
Note 3:
For performing the diagnosis shown below, the following jigs for service is required:
• Flexible cable for service (GGD1309, GGD1447)
6
Press the
0
OPEN/CLOSE button to close the Tray.
(Test disc is clamped.)
7
Press the
STANDBY/ON button to turn off the power.
8
Pull out the Power cord.
Tray Panel
Test Disc
Tweezer
Rear View
Bottom View
1
3
3
4
5
6
6
Slit
1