Downloaded from www.vandenborre.be
Additional information
51
En
Español
Chapter 10:
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
Remedy
The power does not turn
on.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
No sound is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting
your equipment
on page 16).
• Press
MUTE
on the remote control to turn muting off.
• Press
SIGNAL SEL
to select the proper input signal (see
Choosing the
input signal
on page 38).
No image is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting
your equipment
on page 16).
• Select the correct component (use the
MULTI CONTROL
buttons).
• Check
The Input Assign menu
on page 42 to make sure you’re assigned
the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the
instruction manual supplied with the TV.
Considerable noise in radio
broadcasts.
• Connect the antenna (page 25) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 25).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing noise).
VSX-520_SYXCN_En.book 51 ページ ２０１０年４月１２日 月曜日 午後７時１３分
