Connecting up
03
23
En
3-D view of
7.1 channel
speaker setup
AC power cord
After you’ve finished making all connections, plug the
receiver into an AC outlet. The type of cord and the plug
converter which can be used depends on the power
voltage in each region or country. Please make sure you
use the correct cord and plug converter due to the
possibility of fire or other hazard if used incorrectly (see
below).
• Make sure you have completely inserted the AC
power cord into the
AC IN
inlet on the rear panel.
• Do not use any power cord other than the one
supplied with this unit.
• This unit should be disconnected by removing the
power plug from the wall socket when not in regular
use (ex. when on vacation).
Power cord caution
• Handle the power cord by the plug. Do not pull out
the plug by tugging the cord and never touch the
power cord when your hands are wet as this could
cause a short circuit or an electric shock. Do not
place the unit, a piece of furniture, etc., on the power
cord, or pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords should be
routed such that they are not likely to be stepped on.
A damaged power cord can cause a fire or give you
an electrical shock. Check the power cord once in a
while. When you find it damaged, ask your nearest
Pioneer authorized independent service company for
a replacement.
Operating other Pioneer components
Many Pioneer components have SR
CONTROL
jacks
which can be used to link components together so that
you can use just the remote sensor of one component.
When you use a remote control, the control signal is
passed along the chain to the appropriate component.
Note that if you use this feature,
make sure that you also
have at least one set of analog audio or video jacks
connected
to another component for grounding
purposes.
Note
• If you want to control all your components using this
receiver’s remote control, refer to
Controlling the rest
of your system
on page 50.
• If you have connected a remote control to the
CONTROL IN
jack (using a mini-plug cable), you
won't be able to control this unit using the remote
sensor.
AC power cord and converter plug use
Region
Plug type
For European type region
Caution
Do not use this power cord
set in Singapore and
Malaysia.
European two-pin plug
For regions with two pin flat-
bladed plug
Caution
Do not use this power cord
set in Taiwan.
European two-pin plug with two-pin
flat-bladed converter plug
For Taiwan exclusively
Caution
For use in Taiwan only. In
other areas, please do not
use.
Taiwanese two-pin flat-bladed plug
CONTROL
OUT
IN
OUT
IN
CONTROL
Receiver
Remote
control
unit
Other Pioneer products
with CONTROL terminals
Connect to CONTROL
terminal of other
Pioneer products
03_connecting_up.fm 23 ページ
２００４年８月１８日 水曜日 午後４時２６分
