Pioneer VR6C-H310SH, Руководство пользователя

Страница: 8 / 43

− 8 −
English
Before using this product, be sure to read and fully understand the following safety information:
• Do not operate this product if doing so will divert your attention in any way from the safe operation
of your vehicle. Always observe safe driving rules and follow all existing traffic regulations. If you
experience difficulty in operating this product or reading the display, park your vehicle in a safe
location and apply the handbrake before making the necessary adjustments.
• Never set the volume of this product so high that you cannot hear outside traffic and emergency
vehicles.
• Keep this manual handy as a reference for operating procedures and safety information.
• Certain functions (such as viewing of screen and certain button operations) offered by this product
could be dangerous (possibly resulting in serious injury or death) and/or unlawful if used while
driving.
To ensure safe driving
WARNING
• In some countries the viewing of video image on a display inside a vehicle even by persons other
than the driver may be illegal. Where such regulations apply, they must be obeyed.
Precautions before connecting the system
CAUTION
• Firmly install this product so it does not fall off the windscreen. If this product is not firmly installed,
it may fall off the windscreen while driving and cause an accident. Periodically inspect this product.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain
exposed.
• It is extremely dangerous to allow cables to become wound around the steering column or gearstick. Be
sure to install this product, its cables, and wiring away in such so that they will not obstruct or hinder
driving.
• Make sure that the cables and wires will not interfere with or become caught in any of the vehicle’s
moving parts, especially the steering wheel, gearstick, handbrake, sliding seat tracks, doors, or any
of the vehicle’s controls.
• Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires
may become damaged, resulting in a short circuit or malfunction and permanent damage to the
product.
• Do not shorten any cables. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.)
may fail to work properly.
• Never feed power to other electronic products by cutting the insulation of the power supply cable of
this product and tapping into the cable. The current capacity of the cable will be exceeded, causing
overheating.
To prevent damage
WARNING
• When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product.