Pioneer TVM-PW910T, Инструкция по эксплуатации

Страница: 28 / 36

28
Installing the monitor (continued)
Adjusting the shaft guide
■ Shaft guide position (example)
The width between the shaft guides should be 110mm~169mm for a car with shaft diameter less than
14mm.
The narrowest The widest
（
110mm
） （
169mm
）
■
Removing the shaft
guide
Pull up the nut of the
shaft guide from the
rear of the fixture to
remove
■Adjust, install
Shaft guide (left)
Pull to adjust
Shaft guide (right)
Slide to the right/left of
the hole, then change the
position as required to
install.
Or
Shaft guide Hook
Or
Insert the hook’s
gap into the
protrusion of the
fixture, then lock
the claw properly
to install.
Protrusion
Lock the hook
properly into
the fixture to
install.
[How to adjust]
Slide the right
shaft guide to
adjust.
て
If the shaft
diameter is
small, use the
accessories’
cushion tape.
H
ow
to
connec
t
When installed (left) When installed (right)
Cushion tape
(accessories)