Getting started
04
36
En
Basic operation
Procedures for listening to audio from a radio
or connected other component.
1
Turn on the power of the playback
component.
2
Press
SYSTEM to turn on the power of
this system.
3
Select the source you want to playback.
Use the
MULTI CONTROL
(or
INPUT
SELECTOR
) buttons.
• Select the type of audio input signal if
required (see page 36).
4
Start playback of the component you
selected in step 1.
5
Select the listening mode.
Use the listening mode buttons.
6
Press MASTER /– to adjust the
volume.
Choosing the input signal
On this system, it is possible to switch the
input signals for the different inputs as
described below.
1
1
Press
on the remote control.
2
Press SIGNAL SEL to select the input
signal corresponding to the source
component.
When
DIGITAL
(
C1
/
O1
/
O2
) or
HDMI
(
H
) is
selected and the selected audio input is not
provided,
A
(analog) is automatically selected.
Each press cycles through the following:
•
A
– Selects the analog inputs.
•
DIGITAL
– Selects the digital input. The
coaxial 1 input is selected for
C1
, and the
optical 1 or 2 audio input is selected for
O1
or
O2
.
•
HDMI
– Selects an HDMI signal.
H
can be
selected for BD/DVD, TV/SAT or DVR/VCR
input. For other inputs, HDMI cannot be
selected.
2
When set to
DIGITAL
or
HDMI
,
2
lights when
a Dolby Digital signal is input, and
DTS
lights
when a DTS signal is input.
When the
HDMI
is selected, the
A
and
DIGITAL
indicators are off (see page 26).
SYSTEM
SYSTEM
TV CONTROL
CH
VOL
DIMMER SIGNAL SEL
BD MENU
INPUT
INPUT SELECT
SOURCE
TOP
MENU
HOME
MENU
RETURN
ST/MONO
DTV/TV
BASS
TRE
SETUP
PTY SEARCH
AUDIO
PARAMETER
iPod CTRL
MASTER
VOLUME
TOOLS
MENU
ENTER
MUTE
TUNER EDIT
Note
1 • This system can only play back Dolby Digital, PCM (32 kHz to 96 kHz) and DTS (including DTS 96 kHz / 24 bit) digital
signal formats. The compatible signals via the HDMI terminals are: Dolby Digital, DTS, SACD (DSD 2 ch), PCM (32
kHz to 192 kHz sampling frequencies), Dolby TrueHD, Dolby Digital Plus, DTS-EXPRESS, DTS-HD Master Audio and
DVD Audio (including 192 kHz). With other digital signal formats, set to
A
(analog) (
TUNER
).
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise,
make the proper digital connections (page 15) and set the signal input to
C1
/
O1
/
O2
(
DIGITAL
).
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your
DVD player.
2 When the
HDMI
option in
THRU
, the sound will be heard through your
TV, not from this system.
SYSTEM
TV CONTROL
CH
VOL
DIMMER
SIGNAL SEL
BD MENU
INPUT
HTP-500_LXCN_En.book 36 ページ ２００９年１０月１日 木曜日 午後４時５８分
