Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press AUDIO and hold until clock ap-
pears in the display.
Press
AUDIO
repeatedly to switch between
the following settings:
Clock
FM
(FM tuning step)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
AUDIO
until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press AUDIO to select clock.
2 Press
c
or
d
to select the segment of
the clock display you wish to set.
Pressing
c
or
d
will select one segment of the
clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Press
a
or
b
to set the clock.
Pressing
a
will increase the selected hour or
minute. Pressing
b
will decrease the selected
hour or minute.
Turning the clock display on or off
You can turn the clock display on or off.
%
Press CLOCK to turn the clock display
on or off.
Each press of
CLOCK
turns the clock display
on or off.
#
The clock display disappears temporarily
when you perform other operations, but the clock
display appears again after 25 seconds.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
!
If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1 Press AUDIO to select FM.
2 Press
c
or
d
to select the FM tuning
step.
Press
c
to select
50
(50 kHz). Press
d
to se-
lect
100
(100 kHz).
Initial Settings
En
21
English
Section
08
