5
www.pioneerelectronics.com
IMPORTANT:
Follow the instructions for your receiver and set the speakers
to SMALL in the 5.1 mode (Dolby Digital). This will ensure
that any bass signals are re-directed to the subwoofer where
they will be optimally reproduced. If you have a choice, set
the crossover frequency to 150Hz.
CAUTION:
The speakers are equipped with a protection device to protect
the transducers from extreme conditions. Under these
conditions the protection device will activate and stop the
speaker from producing sound. If this happens shut off the
system for 5-10 minutes and allow the protection device to
reset.
PROTECTION PADS
The supplied protection pads can be used to protect the speakers
and the surface they will be placed on. Attach pads at the
bottom of the front, center and rear speakers.
CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
then wipe again with a dry cloth. Do not use furniture wax or
cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will corrode
the surfaces.
SUBWOOFER REAR SECTION
OPERATING YOUR SYSTEM
Turn on your receiver with the level control initially at zero.
Now gradually increase the volume until you reach a com-
fortable listening level.
WARNING:
UNPLUG THE POWERED SUBWOOFER BEFORE
CLEANING TO REDUCE THE RISK OF ELECTRIC
SHOCK
If the subwoofer is placed on a hard floor, such as wood or
tile, place four protective pads on the bottom surface of the
subwoofer.
1
POWER INDICATOR
Illuminates RED when the power is being supplied.
2
VOLUME LEVEL
Volume of subwoofer is adjusted with this knob. Turn this knob
clockwise to raise the level.
• Starting with “MIN“, turn this knob and raise the volume
slowly. If the unit is turned on with the volume set too high, it
could cause hearing and/or speaker damage. Do not turn
the volume up excessively high. The low frequency sound
is apt to be raised too high since it is less disturbing and
harder to detect than high frequencies. Caution must be
taken here since the amplifier and speaker will be clipped
when the output of the amplifier or receiver is increased
with the subwoofer level set to “MAX“.
3
LINE LEVEL IN
Connect SUBWOOFER OUTPUT terminal of the receiver to
this terminal with the supplied RCA cable.
VOLUME
LEVEL
LINE LEVEL
IN
POWER
INDICATOR
1
3
2