10
1
2
3
4
1
2
3
4
C
D
F
A
B
E
S-1EX
2.3.3 Removal/Reattachment of Acoustic absorbent pads
Note:
When reattaching the Network Assy for the midrange/tweeter, before reattaching the closure panel, be sure to remove the
acoustic absorbent pads located behind the chamber. (See Fig. 2-11.) If the closure panel pinches an acoustic absorbent
pad when it is secured, air leakage may occur, which may result in poor performance of this speaker system.
Removal/reattachment of acoustic absorbent pads is necessary before or after removal/reattachment of the Network Assy.
1. Acoustic absorbent pads around the input terminals
2. Acoustic absorbent pads inside the chamber for
the midrange/tweeter
3. Acoustic absorbent pads around the Network Assy
for the midrange/tweeter
Fig. 2-5: After the lower woofer is removed (1)
Fig. 2-6: After the lower woofer is removed (2)
Fig. 2-7: After the lower woofer is removed (3)
Fig. 2-8: After the lower woofer is removed (4)
Fig. 2-9: After the midrange/tweeter is removed (1)
Fig. 2-10: After the midrange/tweeter is removed (2)
Fig. 2-11: After the upper woofer is removed
3
Remove this acoustic
absorbent pad.
When reattaching, fold it in
half lengthwise and push it
in.
1
Remove this acoustic absorbent
pad. When reattaching, roll it
and push it in under the rein-
forcing plate.
As only this acoustic absorbent
pad must be fixed with adhesive,
before pushing it in, apply
adhesive to the side board of the
cabinet.
1
Remove this acoustic absorbent pad.
When reattaching, lay it along the
upper board inside the chamber.
2
Remove this acoustic absorbent pad
When reattaching, place it along the
surface inside the chamber so that it
forms a U shape.
3
Remove this acoustic absorbent
pad from the closure panel section.
When reattaching, fold it in half
lengthwise and push it in.
4
Do not remove the acoustic
absorbent pads around the Network
Assy for
midrange/tweeter
.
Remove the 2 rolled acoustic
absorbent pads stuffed behind the
space of the chamber for
midrange
/tweeter
.
Insert your hand in the direction of
the arrow to remove.
Removal/reattachment of the
Network Assy for the midrange/
tweeter and of the closure panel
must be done in this state.
2
Remove this acoustic absorbent
pad. When reattaching, push it
in along the lower surface of the
reinforcing plate.
Fold the remaining part of the
pad toward the bottom board
side so that it forms an L shape.
The cords from the input
terminals must be pulled out
from the upper side of the
acoustic absorbent pad.
(Adhesive: DIABOND black/GYL-014)
In this state, remove or
reattach the Network Assy.
When reattaching, lay one acoustic absorbent pad on another and
roll them, and make 2 rolls of acoustic absorbent pads.
Place one roll lengthwise, push it into the front of the top board
of the cabinet, then push another beneath of the first one.
