11
En
Installation Procedure
3
Attaching the PDP side metal fitting to the
plasma display.
Attach the PDP side metal fitting to the plasma display
with bolts M8 carefully so the top and bottom are not
accidentally reversed (6 locations).
Note
Spread a sheet or similar material so that the display
will not be scratched or damaged.
Always install it on top of a stable table or similar
surface.
Note
If you plan to install speakers, install them at this stage.
For the installation method, refer to the speaker
installation procedure in the operating instructions for
the plasma display.
4
Installing the wall side metal fitting on the
wall.
Fix it firmly in place symmetrically to the left and right (4
or more locations).
The screws and bolts used for this step vary according
to the strength and the materials of the wall, so prepare
these separately.
Note
Perform this installation work after confirming the
strength of the wall, columns, etc.
Place it so the
top is here.
Attachment holes
(attached symmetrically on the left
and right: 4 or more locations)
1
First decide the position to install the plasma display as
you check the strength of the wall and beam, then set
the location at the center of the screen.
Center of
the screen
2
Temporarily attach the screw used for positioning about
230mm above the center of the screen. After the metal
fitting is fixed by the temporarily attached screw,
remove it if it is not necessary.
230mm
Center of the screen
4
Measure the distance from the ceiling to the wall side
metal fitting (A
1
, A
2)
and the distance from the floor to
the metal fitting (B
1
, B
2
), then after adjusting it so it is
horizontal, fasten it to the wall with bolts.
Hanging the wall side
metal fitting on the screw.
3
Hang the wall side metal fitting on the screw referred to
in step
2
.
Ceiling
Floor
A
1
B
1
A
2
B
2
A
1
= A
2
or
B
1
= B
2
Temporarily
attaching the
screw
