12
En
M8
12 mm to 15 mm
(1/2 inch to 5/8 inch)
Using a wall for stabilization
1
Attaching falling prevention bolts (hooks)
to the Plasma Display.
2
Using strong cords to firmly stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right
sides.
Note
Use hooks, cords, and fittings that
are available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm (1/2 inch to 5/8 inch)
Caution
• A table or an area of the floor with adequate strength
should always be used to support the Plasma
Display.
Failure to do so could result in personal injury and
physical damage.
• When installing the Plasma Display, please take the
necessary safety measures to prevent it from falling
or overturning in case of emergencies, such as
earthquakes, or of accidents.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks, chains and other fittings that you
use to secure the Plasma Display to prevent it from
overturning will vary according to the composition
and thickness of the surface to which it will be
attached.
• Select the appropriate screws, hooks, chains and
other fittings after first inspecting the surface
carefully to determine its thickness and composition
and after consulting a professional installer if
necessary.
After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Preventing Equipment from Falling Over
Min. 20 mm
(13/16 inch)
6 mm
(1/4 inch)
9 mm to 15 mm
(3/8 inch to 5/8 inch)
Stabilizing on table
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on a
table, use screws that have a
nominal diameter of 6 mm (1/4
inch) and that are at least 20 mm
(13/16 inch) long.
Position of screws
When stabilizing the stand to a table, use nominal
diameter 6 mm (1/4 inch) with a length above
20 mm (13/16 inch).
Unit: mm (inch)
301 (11-27/32)
29 (1-1/8)
120
(4-23/32)
581
(22-7/8)
11 (13/32)
Side View
1
Hook
2
Cord
Fitting
