X:\print\Pioneer\19_DEH\UC\19_865UC_QRI3108(A6_Vertical)\020Chapter_EN.f
m
MVH-S512BS
19_865UC_QRI3108(A6_Vertical)
- 25 -
- 25 -
En
g
lis
h
You can adjust the cut-off frequency value and the slope value of each speaker.
The following speakers can be adjusted.
Network mode:
[HIGH] (high-range speaker HPF), [MID HPF] (middle-range speaker HPF), [MID LPF]
(middle-range speaker LPF), [SUBWOOFER]
Standard mode:
[FRONT], [REAR], [SUBWOOFER]
NOTE
[SUBWOOFER] can only be selected when [ON] is selected in [SUBWOOFER] (page 29).
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [AUDIO], then press to confirm.
3
Turn the
M.C.
dial to select [CROSSOVER], then press to confirm.
4
Turn the
M.C.
dial to select the speaker unit (filter) to be adjusted, then press to
confirm.
5
Turn the
M.C.
dial to select [HPF] or [LPF] according to the speaker unit (filter),
then press to confirm.
6
Turn the
M.C.
dial to select an appropriate cut-off frequency for the speaker unit
(filter) selected in step 4, then press to confirm.
Network mode:
[1.25K] to [12.5K] (if you choose [HIGH] or [MID LPF])
[25] to [250] (if you choose [MID HPF] or [SUBWOOFER])
Standard mode:
[25HZ] to [250HZ]
7
Turn the
M.C.
dial to select an appropriate slope for the speaker unit (filter)
selected in step 4.
Network mode:
[–6] to [–24] (if you choose [HIGH], [MID HPF] or [MID LPF])
[–12] to [–36] (if you choose [SUBWOOFER])
Standard mode:
[–6] to [–24] (if you choose [FRONT] or [REAR])
[–6] to [–36] (if you choose [SUBWOOFER])
Adjusting the cut-off frequency value and the slope
value
