Pioneer MVH-7300, Руководство по эксплуатации

Страница: 34 / 52

5 Use M.C. to enter the auto EQ measure-
ment mode.
Turn to change the menu option. Press to se-
lect.
6 Plug the microphone into the micro-
phone input jack on this unit.
7 Press M.C. to start auto EQ.
8 When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
A measurement tone (noise) is emitted from
the speakers, and auto EQ measurement be-
gins.
#
It takes about nine minutes for auto EQ mea-
surement to be completed when all the speakers
are connected.
#
To stop auto EQ, press
M.C.
9 When auto EQ is completed, Complete
is displayed.
When the car
’
s interior acoustic characteris-
tics cannot be measured correctly, an error
message will be displayed. (Refer to
Under-
standing auto EQ error messages on page 40.)
10 Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period, high tempera-
tures may cause distortion, color change or
malfunction.
Other functions
Using an AUX source
When connecting auxiliary device using the
front AUX input.
!
You need to activate the AUX setting in the
initial setting menu. Refer to
AUX Input
(auxiliary input) on page 30.
!
If an iPod with video capabilities is con-
nected to this unit via 3.5 mm plug (4 pole)
cable (such as the CD-V150M), you can
enjoy the video contents of the connected
iPod.
!
A portable audio/video player can be con-
nected by using a 3.5 mm plug (4 pole) with
an RCA cable (sold separately). However,
depending on the cable, a reverse connec-
tion between the red (right side audio)
cable and yellow (video) cable may be re-
quired in order for the sound and video
image to be reproduced correctly.
%
Insert the mini plug into the AUX input
jack on this unit.
For more details, refer to Head unit on page 8.
This auxiliary device is automatically set to
AUX .
Function settings
1 Press M.C. to display the function
menu.
2 Turn M.C. to select the function.
After selecting, perform the following proce-
dures to set the function.
A/V Change (auxiliary device signal setting)
1
Press
M.C.
to display the setting mode.
2
Turn M.C. to select the desired setting.
!
Audio
–
auxiliary device connected with a
stereo mini plug cable
!
Video
–
auxiliary video device connected with
4-pole mini plug cable (e.g., CD-V150M)
3
Press M.C. to confirm the selection.
Display (display setting)
En
34
Section
03
Operating this unit