Pioneer FH-S525BT, Быстрый старт

Страница: 7 / 72

7
En
En
g
lis
h
You can adjust various settings in the main menu.
1
Press the M.C. dial to display the main menu.
2
Turn the M.C. dial to select one of the categories below, then press to confirm.
• FUNCTION settings
• AUDIO settings
• SYSTEM settings
• ILLUMINATION settings
• MIXTRAX settings
• MICROPHONE settings
3
Turn the M.C. dial to select the options, then press to confirm.
Settings
• This product (×1)
• Truss screw (5 mm × 9 mm) (×4)*1, (×6)*2
• Trim ring (×1)
• Mounting sleeve (×1)
• Power cord (×1)
• Microphone (3 m) (×1)
• Remote Control (×1)
• Extraction key (×2)
*1 MVH-S425BT
*2 FH-S725BT/S525BT
(Network mode is only available for FH-
S725BT.)
In the following, "NW" represents network
mode and "STD" represents standard
mode. According to the connections you
have established, change the speaker
mode to standard mode (STD) or network
mode (NW).
WARNING
• When speaker output is used by 4
channels, use speakers over 50 W
(maximum input power) and between 4
Ω to 8 Ω (impedance value). Do not use 1
Ω to 3 Ω speakers for this unit.
• When rear speaker output is used by 2 Ω
of subwoofer, use speakers over 70 W
(maximum input power).
* Please refer to connections for a
connection method.
• The black cable is ground. When
installing this unit or power amp (sold
separately), make sure to connect the
ground wire first. Ensure that the ground
wire is properly connected to metal parts
of the car’s body. The ground wire of the
power amp and the one of this unit or
any other device must be connected to
the car separately with different screws. If
the screw for the ground wire loosens or
falls out, it could result in fire, generation
of smoke or malfunction.
Important
• When installing this unit in a vehicle
without an ACC (accessory) position on
the ignition switch, failure to connect the
red cable to the terminal that detects
operation of the ignition key may result
in battery drain.
• Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a fire or malfunction.
• To prevent a short-circuit, overheating or
malfunction, be sure to follow the
directions below.
– Disconnect the negative terminal of the
battery before installation.
– Secure the wiring with cable clamps or
adhesive tape. Wrap adhesive tape
around wiring that comes into contact
with metal parts to protect the wiring.
Connections/Installation
Supplied part list
Connections
Ground wire POWER AMP
Other devices
(Another electronic
device in the car)
Metal parts of
car’s body
*1 Not supplied for this unit
ACC position No ACC position