Installation using the screw holes on the side of the unit
Fastening the unit to the factory radio mounting bracket. (Fig. 4) (Fig. 5)
Select a position where the screw holes of the bracket and
the screw holes of the head unit become aligned (are fit-
ted), and tighten the screws at 3 or 4 places on each side.
Use either truss screws (5
×
8 mm) or flush surface screws
(5
×
9 mm), depending on the shape of the screw holes in
the bracket
.
Fig. 4
Fig. 5
Installation
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all connected
up properly, and the unit and the system work
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the driver’s
way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• The semiconductor laser will be damaged if it
overheats, so don’t install the unit anywhere hot
— for instance, near a heater outlet.
• If installation angle exceeds 30° from horizontal,
the unit might not give its optimum performance.
(Fig. 3)
Fig. 3
• In some types of automobiles, discrepancy may
occur between the main unit and the dashboard. If
this happens, use the supplied panel to fill the gap
(peel off the protection tape before use).
30˚
Screw
Be sure to use the screws
supplied with this product.
Dashboard or Console
Factory radio mounting bracket
<ENGLISH>
If the pawl gets in the
way, bend it down.
