Pioneer Elite VSX-60, Руководство по обслуживанию

Страница: 49 / 138

49
VSX-1127-K
5 6 7 8
5 6 7 8
A
B
C
D
E
F
8 .2 USB BACKUP
[Re q uirements for USB memory]
USB memory to be used should meet the following requirements.
!
Compatible with USB Mass storage Class
!
With a file system of FAT (FAT32)
[File saving format]
Files are to be saved in the following format:
Example: VSX-1127_BK01.avr
[How to save in the USB memory from AV amplifier]
1. Insert the usable USB memory into the USB terminal when the main device is off.
2. Enter the SERVICE MODE and select [USB BAK
c HOLD d ] with
g
keys.
(See [6.1 TEST MODE] for how to enter the SERVICE MODE.)
3. Select [USB BAK c SAVE? d ] with
h
keys and press [ENTER].
Note: The system cannot execute SAVE, LOAD until start is completed of BridgeCo.
4. Saving in the USB starts and the main device automatically goes off after the normal completion
([COMPLETE]
is displayed.).
5. Remove the USB and saving is finished.
*1. If the following errors occur after "SAVE" is executed, error message will be displayed and "SAVE" will be stopped and
the power will be turned off.
• Ejecting of USB device
• Short capacity of USB device
• Error during writing in the USB device (Read Only or defective Sector, etc.)
*2. If the same file name exists in the USB, overwriting will be automatically executed.
[How to write into AV amplifier from the USB memory]
[Introduction]
This model is capable of saving the set values stored in the MAIN Ucom of D-MAIN Assy in the USB and loading them in a
new D-MAIN Assy. (Note that MAIN Ucom should normally operate to enable this function.)
When replacing D-MAIN Assy, execute the above mentioned processes.
[Data that can be saved/cannot be saved]
The following data can not be saved. Data other than these can be saved.
Contents to save Destination to save
Last memory for turning ON/OFF the Main power and power supply for ZONE2
Last memory for inputting the Main power, ZONE2
Setting for controlling HDMI
Remote control ID
Setting for Network Standby
Data to be save upon the operation of protection circuit
Standby Through setting
EVENT Ucom
Settings for HMG
Favorite, Recently played, Repeat
BridgeCo IC
(As the data saved by EVENT Ucom is on the FRONT Assy, the data cannot be deleted unless Assy
is replaced at the same time.)
1. Insert the USB with the saved file into the USB terminal when the main device is off.
2. Enter the TEST MODE and select [USB BAK
c
HOLD
d
] with
g
keys.
(See [6.1 TEST MODE] for how to enter the TEST MODE.)
3. Select [USB BAK c LOAD? d ] with
h
keys and press [ENTER].
4. Saving in the main device starts and it automatically goes off after the normal completion ([COMPLETE] is displayed.).
5. Remove the USB and loading is finished.
* If the following errors occur after "LOAD" is executed, error message will be displayed and "LOAD" will be stopped and
the power will be turned off.
• No setting file
• Mismatching between the setting file and the specification of the A/V RECEIVER type to be loaded back
• Error due to Checksum, Signature Check, and Size Check
• Ejecting of USB device (during reading of the setting file)