SET UP
OPERA
TION
7
<ARB7181>
Introductory Information
Operating other PIONEER components
Receiver Installation
• Do not place objects directly on top of this unit. It will prevent proper heat dispersal.
• When installing in a rack, etc., be sure to leave more than 8 inches of space above the receiver.
You can also control PIONEER components
(and those made by other manufacturers) by
pointing the receiver’s remote control directly
at the respective component. This type of
operation does not require control cords. All
you have to do is recall the appropriate preset
code (Refer to “Recalling preset codes” on
page 22).
memo
It is recommended that you place the
receiver to the left of your cassette and/
or video decks. This will prevent noise
caused by leakage flux from the
transformer in the receiver. If you
experience noise during playback of
your cassette and/or video decks, move
them farther away from the receiver.
Receiver
Leave more than 8 inches (20 cm)
When Making Cable Connections
Be careful not to arrange cables in a manner that bends
the cables over the top of this unit as shown in the
illustration. If the cables are brought over this unit, the
magnetic field produced by the transformers in this unit
may cause a humming noise to come from the speakers.
Remote Control
Receiver
To CONTROL IN
terminal of another
PIONEER component
bearing the
Î
mark.
PIONEER component
bearing the
Î
mark.
Connecting an optional control cord allows you to
operate other PIONEER components simply by pointing
the receiver’s remote control at the remote sensor on the
front panel of the receiver. The receiver then sends the
remote control signals to the other devices via the
CONTROL OUT terminal.
Operating range of remote control unit
30
30
23 feet(7m)
Remote control may not function properly if :
• There are obstacles between the remote
control and the remote sensor.
• Direct sunlight or fluorescent light is shining
onto the remote sensor.
• The receiver is located near a device
emitting infrared rays.
• Operated simultaneously with another
remote control which uses infrared rays.
Point the remote control toward the remote sensor
Î
on
the front panel of this unit to operate. The remote control
unit will operate the receiver for up to a distance of 23
feet (7 m) within 30° angle on each side of the sensor of
the remote sensor as illustrated below.
OUT
IN
CONTROL
OUT
IN
CONTROL
memo
memo
