6
En
14 Attach the butyl rubber tapes on the inside of the
grille.
15 Attach the grille to the speaker.
When installed vertically, the speaker grille has a specific
mounting orientation. Gently push the grille onto the
speaker, lining up the corners of the grille to the grooves
in the speaker. Then line up the entire grille to the
grooves in the speaker and attach the grille by pressing
in on the edges.
• Once you have pushed it in, make sure you press it
firmly against the speaker so that the grille doesn’t
fall off and cause an accident.
• To remove the grille, use the supplied tool to hook
into the holes located near the corners and pull the
grille out. When doing this, make sure to pull all four
corners out evenly. Forcing the grille out from one
corner alone will cause the grille to be deformed.
Connections
Connecting to an amplifier
Make sure you have read the connection instructions in
the manual supplied with the amplifier and that all
equipment is turned off before making any connections.
• When using a set of speakers connected to an
amplifier, you won’t be able to obtain the correct
stereo effect if the polarity (+, –) of one of the
speakers (left or right) is reversed.
Additional Information
Cleaning the speaker
Use a dust brush to wipe off dust and dirt.
Never use furniture wax, cleaners, thinners, benzine,
insecticide sprays or other chemicals on or near the
speakers, since these will corrode the surfaces.
Attach the eight butyl rubber tapes to each
grille, lining up the butyl rubber tapes to
the marks on the inside of the grille.
Then peel off the protective paper.
Make sure to press on the edges.
Pressing on the middle of the
grille will cause it to be deformed.
When setting the speaker
vertically, orient the grille
so that the red mark on
the grille edge is toward
the top of the speaker.
S-IW691L_SRD1386A.book 6 ページ ２００８年８月１８日 月曜日 午後１時４３分
