Pioneer DV-696AV-K, Руководство по эксплуатации

Страница: 54 / 128

Additional information 08
54
En
Selecting languages using the
language code list
Some of the language options (such as ‘DVD
Menu Lang.’ in the Setup Navigator) allow you
to set your preferred language from any of the
136 languages listed in the language code list
on page 61.
1 Select ‘Other Language’.
2 Use the
/
(cursor left/right) buttons
to select either a code letter or a code
number.
3 Use the
/
(cursor up/down) buttons
to select a code letter or a code number.
See Language code list on page 61 for a
complete list of languages and codes.
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Inspect the other components and electrical appliances being used. If the
trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized
service center or your dealer to carry out repair work.
Problem Remedy
The disc won’t play or is
automatically ejected
after loading. • Make sure the disc is free from dirt and dust and is not damaged
(page 51).
• Make sure the disc is loaded with the label side face-up and aligned
properly in the disc tray guide.
• Incompatible region number: If the region number on a DVD-Video
disc does not match the number on the player, the disc cannot be
used (page 53). In this case the attention sentence “Incompatible disc
region number Can't play disc” is displayed on screen.
• Condensation inside the player: Allow time for condensation to
evaporate. Avoid using the player near an air-conditioning unit.
• Disc is loaded upside down: Reload the disc with the label side face
up.
• A Super VCD that does not conform with the IEC standards might
not play normally.
DVD-Audio playback
stops.
• The disc may have been illegally copied.
Picture playback stops
and the operation
buttons cannot be used.
• Press , then start playback again ( ).
• Press and hold the front panel STANDBY/ON button for about 10
seconds to switch the unit off, then press again to switch back on.
• Switch the power off once, unplug from the wall socket, then plug
back in and switch on again using the front panel
STANDBY/ON
button.
DV696AV_WY_EN.book 54 ページ ２００６年４月７日 金曜日 午後６時４８分