Pioneer DMH-Z6350BT, Быстрый старт

Страница: 16 / 152

14
En
2
Fasten this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
TIP
The amount of this unit's protrusion from
the dashboard/console can be adjusted by
shifting the position of the screw hole of
this unit to the factory radio-mounting
bracket.
Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Binding head screw (8 mm)
Be sure to use the screws supplied
with this product.
3
Fasten the LCD screen mounting
bracket to the main unit at the suitable
position.
LCD screen mounting bracket
Binding head screw (4 mm × 6 mm)
TIP
The mounting left-centre-right position of
the LCD screen mounting bracket can be
changed depending on the vehicle or
installation location of the main unit.
4
Detach the monitor cable cover from
the LCD screen ( ), then connect the
monitor cable to the LCD screen (
).
After that, attach the LCD screen with
adjusting the up-down position ( ) to
this unit by using the screws each side
(
).
Monitor cover
Binding head screw (4 mm × 12 mm)
5
Secure the monitor cable to the hook
on the back of the LCD screen then
attach the monitor cover (
) by using
the screws ( ).
Monitor cover
Machine screw (2 mm × 4 mm)
▶
DMH-ZS9350BT
Installation tips
The following procedure describes how to
use the supplied parts to install this
product with the LCD screen attached to
the unit. It is also possible to install this
product so that the LCD screen is separate
from the unit. For details, visit the Pioneer
website for your region.
For some types of vehicles, it is necessary
to use an installation kit (sold separately)
when installing. For details, visit the
Pioneer website for your region.
1
First attach the supplied side brackets
to the LCD screen (
), then attach
them to this unit ( ). After that,
connect the monitor cable to the LCD
screen (
).
Side bracket (for attaching LCD
screen to unit)
Binding head screw (5 mm)
Be sure to use the screws supplied
with this product.
Monitor cable
Attach the monitor cable to the unit
with heat resistant tape (sold
separately).
Some vehicles require the use of special
parts. Refer to the following illustration
when installing.