12
En
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*3 Not available when [OFF] is selected in [SUB.W].
You can also access to these menus when the unit is turned off.
AUDIO settings
Menu Item
Description
FADER
*1
Adjust the front and rear speaker balance.
BALANCE
Adjust the left and right speaker balance.
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM1],
[CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band:
[80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level:
[+6] to [–6]
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
•
USB, iPod, PANDORA (iPhone), and APP
(iPhone)
[CUSTOM2] is a shared setting used for all
sources.
LOUDNESS
[OFF], [LOW], [MID], [HI]
Compensate for clear sound at low volume.
SUB.W
*2
[NOR], [REV], [OFF]
Select the subwoofer phase.
SUB.W CTRL
*2*3
Cut-off frequency:
[50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level:
[–24] to [+6]
Slope level:
[–12], [–24]
Only frequencies lower than those in the
selected range are output from the subwoofer.
BASS BOOST
[0] to [+6]
Select the bass boost level.
HPF SETTING
Cut-off frequency:
[OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level:
[–12], [–24]
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
SLA
[+4] to [–4]
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
•
USB, iPod, PANDORA (iPhone), and APP
(iPhone)
SYSTEM settings
Menu Item
Description
CLOCK SET
Set the clock (page 6).
12H/24H
[12H], [24H]
Select the time notation.
INFO DISPLAY
Display the item on the sub information display.
Select from “SPEANA,” “LEVEL METER,” “SOURCE,”
“CLOCK,” and “OFF.”
AUX
[ON], [OFF]
Set to [ON] when using an auxiliary device
connected to the unit.
Menu Item
Description
