Pioneer DEH-M8047ZT/UC, Руководство по обслуживанию

Страница: 85 / 107

3
5
6 7 8
F
E
D
C
B
A
5 6 7 8
CX-3057
1.1 PREAMPLIFIER BLOCK (UPD63760GJ: IC201)
In the preamplifier block, the pickup output signals are processed to generate signals that are used for the next-stage
blocks: the servo block, demodulator, and control.
After I/V-converted by the preamplifier with built-in photo detectors (inside the pickup), the signals are applied to the
preamplifier block in the CD LSI UPD63760GJ (IC201). After added by the RF amplifier in this block, these signals are
used to produce necessary signals such as RF, FE, TE, and TE zero-cross signals.
The CD LSI employs a single power supply system of + 3.3V. Therefore, the REFO (1.65V) is used as the reference volt-
age both for this CD LSI and the pickup. The LSI produces the REFO signal by using the REFOUT via the buffer amplifi-
er and outputs from the pin 131. All the measurements should be made based on this REFO.
Caution: Be careful not to short the REFO and GRD when measuring.
1.1.1 APC (Automatic Power Control)
A laser diode has extremely negative temperature characteristics in optical output at constant-current drive. To keep
the output constant, the LD current is controlled by monitor diodes. This is called the APC circuit. The LD current is
calculated at about 30mA, which is the voltage between LD1 and V3R3D divided by 7.5 (ohms).
Fig. 1.1.1 APC
6.5 k
+
-
1 k
100 k
+
-
6.5 k
100 k
+
-
110 k
1 k
REG 1.25 V
Vref
3 p
142
143
140
PD
PN
LDREGO
LD
UPD63760GJ
141
+
+
100 p
10
µ
0.1
µ
5
7
15
5
7
15
14 14
PICKUP UNIT(SERVICE)(P10)
CD CORE UNIT(S10MP3)
1.5 x 5
2SB1132
1SS355
100 / 16
LD-
LD+
MD
MD
VR
LDS
APN