En
12
Rear panel
2
3
5
5
9
b
c
d
a
1
4
78
6
1
Kensington security slot
2
BOOTH output terminal
These are the output terminals for a booth monitor. Compatible with
balanced or unbalanced output for 1/4” TRS connectors.
The master channel sound can be output from the [
BOOTH
] output
terminals regardless of the audio level set for the master channel.
!
The sound will be distorted if the level is raised too high when
using unbalanced outputs.
!
The booth monitor output is set to output the microphone sound
by default. It is possible to set not to output the microphone
sound in [
Preferences
] of rekordbox.
3
MASTER 2 terminals
Connect to a power amplifier, etc.
!
Compatible with RCA pin-jack type unbalanced outputs.
4
MASTER 1 terminals
Connect powered speakers, etc., here.
!
Compatible with XLR connector type balanced outputs.
5
PHONO/LINE input terminals
Connect a phono level (for MM cartridges) output device (analog
player, etc.) or a line level output device (DJ player, etc.). Switch
the input source according to the connected device using the
[
LINE/PHONO
] switch on this unit’s rear panel.
6
LINE/PHONO switch
Selects the input source of each channel from the components con-
nected to this unit.
—
[
PHONO
]: Select this to use a phono level (for MM cartridges)
output device (analog player, etc.) connected to the [
PHONO/
LINE
] input terminals.
—
[
LINE
]: Select this to use a line level output device (DJ player,
etc.) connected to the [
PHONO/LINE
] input terminals.
!
Different input sources cannot be selected for both channels.
7
PC MIX switch
Switch the audio route of the external device connected to the
[
PHONO/LINE
] input terminal or [
MIC
] input terminal of this device.
=
Using external inputs
(p. 26 )
8
SIGNAL GND terminal
Connects an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
9
MIC input terminal
Connects a microphone here.
Compatible with a 1/4” TS jack.
a
USB
terminal
Connect to a computer.
!
Connect this unit and the computer directly using the included
USB cable.
!
A USB hub cannot be used.
b
DC IN terminal
Connect to a power outlet using the included AC adapter (with the
included power cord connected).
!
Connect the AC adapter after all the connections between
devices have been completed.
!
Only use the included AC adapter.
c
Cord hook
Catch the AC adapter’s power cord and USB cable on this hook
when using this unit.
!
The sound will be interrupted if the AC adapter or USB cable is
disconnected during playback.
d
STANDBY/ON switch
This switches this unit’s power between on and standby.
Front panel
1
2
3
1
PHONES output terminals
Connect headphones here.
Compatible with a 1/4” TRS jack and 3.5 mm stereo mini jack.
!
There are two input jacks, both a stereo phones jack and a mini
phones jack, but do not use both simultaneously. If both are used
simultaneously, when one is disconnected and/or connected, the
volume of the other may increase or decrease suddenly.
2
HEADPHONES LEVEL control
Adjusts the level of audio output from the [
PHONES
] output
terminals.
3
MIC LEVEL control
Adjusts the level of audio input to the [
MIC
] input terminals.
