Turning the built-in speaker
output on or off
%
Press SPEAKER to turn the built-in
speaker output off.
OFF
appears in the display.
#
To turn the built-in speaker output on, press
SPEAKER
again.
Built-in speaker output is now on and
AUDIO
ap-
pears in the display.
Adjusting the head unit
volume
You can adjust the head unit volume by
VOLUME
on the supplied remote control.
1 Press AVX/H.U and hold to switch
VOLUME operation.
It enables
VOLUME
on the remote control to
adjust the head unit volume.
#
To enable
VOLUME
to adjust the built-in
speaker volume, press
AVX/H.U
and hold again.
2 Press VOLUME on the remote control to
adjust the volume.
Turning the unit off
SOURCE mode (
S
)
%
Turn this unit off fromyour head unit.
Refer to the head unit operation manual.
#
If you press
AV SOURCE
and hold to turn this
unit off,
Power off (POWER OFF)
appears on the
head unit
s display.
MASTER mode (
M
)
%
Press AV SOURCE and hold until the
unit turns off.
Opening and closing the
LCD panel
The LCD panel will be opened or closed auto-
matically with the turning of the ignition
switch on or off. You can turn off the automatic
close/open function. (Refer to page 28.)
!
Do not close the LCD panel with hands by
force. That cause malfunction.
!
The automatic close/open function will op-
erate the display as follows.
When the ignition switch is turned OFF
while the LCD panel is opened, the LCD
panel will close after six seconds.
When the ignition switch is turned ON
again (or turned to ACC), the LCD panel
will be opened automatically.
!
When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press
OPEN/CLOSE
to open the
LCD panel.
!
When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
%
Press OPEN/CLOSE to open the LCD
panel.
#
To close the LCD panel, press
OPEN/CLOSE
again.
Adjusting the LCD panel angle
Important
!
If you can hear the LCD panel knocking
against your vehicle
s console or dashboard,
press
ANGLE (
)
to move the LCD panel a lit-
tle forward.
!
When adjusting the LCD panel angle, be sure
to press
ANGLE (+/
)
. Forcibly adjusting the
LCD panel by hand may damage it.
Basic Operations
En
9
English
Section
04