13
Installation
DIN Rear-mount
Installation using the screw holes on
the side of the unit
• Fastening the unit to the factory
radio mounting bracket. (Fig.
14) (Fig. 15) (Fig. 16)
Select a position where the screw holes
of the bracket and the screw holes of
this product become aligned (are fit-
ted), and tighten the screws at 2 places
on each side. Use any of binding
screws (4
×
3 mm), binding screws (5
×
6 mm) or flush surface screws (5
×
6
mm), depending on the shape of the
screw holes in the bracket.
*1 Use binding screws (4
×
3 mm) only.
Fig. 14
• When installing in a shallow space,
use the following screw holes. In
this case, stick conceal tape on parts
that protrude from the dashboard.
Fig. 15
Fig. 16
Switching the operation mode
This unit features two operation
modes: the IP-BUS mode (
S
) and the
ADD-ON mode (
M
). Switch the mode
according to the combined compo-
nents.
• IP-BUS mode (
S
) – Using with a
Pioneer head unit featuring an IP-
BUS input or multi-channel proces-
sor control unit
• ADD-ON mode (
M
) – Using with a
car stereo featuring RCA audio
inputs or FM reception capability
• Use a thin standard tip screw-
driver to switch the operation
mode switch on the back of this
unit. (Fig. 17)
Fig. 17
• After switching, reset the micro-
processor.
Screw
Dashboard or
Console
Factory radio mounting
bracket
*1
*1
Conceal tape
*1
*1
