Pioneer AVX-7000, Руководство по обслуживанию

Страница: 28 / 32

34
AVX-7000
-
Discharging operations
1. When the OPEN key or the ACC is turned “ON”(or
detach grille installing ), (2 sec. after) the position
motor will be activated under the high speed mode.
2. When the longitudinal position sensing switch (PUSH
SW)/(LIFT SW) turns H - L, the position motor will be
stopped and, at the same time, the angle motor will
be activated at high speed.
3. When the electric potential of the angle encoder
reaches 90° (Reference 0° pot 3.047V), the
angle motor will be stopped. (Braking mode)
However, if the preceding angle is being memorized,
the angle motor will keep running until the
memorized angle can be obtained.
-
Storage operation
1. When the CLOSE key is operated (or 6 sec. after
turning “OFF” the ACC while the automatic open-
close setting is being turned “ON”), the angle motor
will be activated at low speed.
2. At 750ms after the angle 0° potential has been
reached, the angle motor will be stopped and the
position motor will be activated at high speed. The
system will go into stopping movement at the point
where the PULL SW is turned “ON” by detection or
when the error time is over.
90° potential or
the memorized
position