Pioneer AVIC-X3 II, Руководство по установке

Страница: 12 / 182

Connecting the power cord (2)
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST
BE CONNECTED TO THE POWER SUPPLY SIDE OF THE
HANDBRAKE SWITCH. IMPROPER CONNECTION OR
USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW
AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
Light green
Used to detect the ON/OFF status of the handbrake. This lead must be
connected to the power supply side of the handbrake switch.
If this connection is made incorrectly or omitted, certain functions
of your navigation system will be unusable.
Speed detection circuit lead
Power supply side
Earth side
Handbrake switch
Extension lead
(for speed signal)
Connection method
Clamp the handbrake switch
power supply side lead.
Clamp firmly with needle-nosed
pliers.
Connection method
Pass the extension cord
and the lead for the speed
detection circuit through
this hole.
Clamp firmly with
needle-nosed
pliers.
Close the cover.
Vehicle injection
computer
Connector
The position of the speed
detection circuit and the
position of the handbrake
switch vary depending on the
vehicle model. For details,
consult your authorised
Pioneer dealer or an
installation professional.
Note
WARNING
The hide-away unit
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE
OR INJURY INCLUDING ELECTRICAL SHOCK, AND
INTERFERENCE WITH THE OPERATION OF THE VEHICLE´S
ANTILOCK BRAKING SYSTEM, AUTOMATIC GEARBOX AND
SPEEDOMETER INDICATION.
Pink (CAR SPEED SIGNAL INPUT)
The mobile navigation system is connected here to detect the
distance the vehicle travels. Always connect the vehicle’s speed
detection circuit or the ND-PG1 speed pulse generator, sold
separately. Failure to make this connection will increase errors in
the location display.
WARNING
5 m
Connecting the System
Engb
12
Section
03