Pioneer AVIC-F930BT, Руководство по обслуживанию, Страница: 148 / 304

AVIC-X930BT/XNUC
148
1 2 3 4
1 2 3 4
C
D
F
A
B
E
1
Fig.4
-
Removing the CC Monitor Unit (Fig.4)
Remove the two screws
and then remove the Holder and Cover.
2
Fig.5
Peeling the Tape.
6
Disconnect the FFC.
-
Removing the Keyboard PCB (Fig.5)
Attention at assembly)
Lace FPC that connects
LCD Panel and CC Monitor Unit
into the hole of Holder.
1
Remove the ten hooks.
and then remove the Holder.
Attention at assembly)
Lace FFC that connects LCD Panel and
CC Monitor Unit into the hole of Holder.
Attention at assembly)
The connector lever is small and hard,
lock it surely.
Attention at assembly)
When you attach Cord Assy,
fix it with tape so that Cord Assy
does not contact the edge of the plate.
Remove the screw
and then remove the SD Unit.
3
4
5
Disconnect the Cord Assy using GGF1539.
Attention)
Remove Cord Assy from the connector on Keyboard PCB side.
It cannot be removed from BT Unit side.
Disconnect the four cables.
Remove the four screws
and then remove the CC Monitor Unit.
When you remove the Holder from the Grille,
you can disassemble them easily by removing
the hook in the order shown below.
1.Remove three hooks on the right side on the rear face
2.Remove four hooks on the lower surface
3.Remove three hooks on the left side on the rear face
3
2
Remove the Knob Unit.
Remove the two screws
and then remove the Keyboard PCB.
Tape
1
3
2
Holder
1
Holder and Cover
CC Monitor Unit
SD Unit
Tape
4
5
5
5
5
5
6
6
6
6
1
1
1
1
1
1 1 1
1
1
Remove the LCD Panel and Touch Panel.
(not shown)
Knob Unit
2
Keyboard PCB
3
3