Pioneer AVIC-5100NEX, Руководство по установке

Страница: 28 / 72

Black plate (28,1)
!
The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
!
The semiconductor laser will be damaged
if it overheats, so don
’
t install this product
anywhere hot
—
for instance, near a heater
outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-6100-
NEX and AVIC-5100NEX.
This product Truss head screw
(5 mm × 8 mm)
(6 pcs.)
Flush surface screw
(5 mm × 9 mm)
(6 pcs.)
Screw*
(2 mm × 4 mm)
(1 pc.)
Installation using the screw
holes on the side of this product
%
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the brack-
et
’
s screw holes.
If the pawl interferes with installation,
you may bend it down out of the way.
1
2
3
1
Factory radio-mounting bracket
2
Dashboard or console
3
Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
<CRD4852-A>28
En
28
Section
03
Installation