54
En
•
The cords must not cover up the area
shown in the figure below. This is
necessary to allow the amplifiers to
radiate freely.
Do not cover this area.
•
Make sure you leave enough gap
between the dashboard and the LCD
panel of this unit so the LCD panel can be
opened and closed without contacting
with the dashboard.
Dashboard
Leave gap
LCD panel
This unit can be properly installed using
either front-mount or rear-mount
installation. Use commercially available
parts when installing.
1
Decide the position of the side
brackets.
When installing in a shallow space,
change the position of side brackets
(small).
Side bracket (small)
Flush surface screw (5 mm × 6 mm)
2
Install the unit into the dashboard.
Insert the mounting sleeve into the
dashboard. And then secure the
mounting sleeve by using a screwdriver
to bend the metal tabs (90°) into place.
DIN front/rear-mount
Leave ample
space
5 cm
5 cm
DIN Front-mount
Dashboard
Mounting sleeve
Side bracket
Screw (2 mm × 3 mm)
1
Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
When installing in a shallow space, use
the following screw holes.
Use binding screws (4 mm × 3 mm)
only.
2
Tighten two screws on each side.
Use any of binding screws (4 mm × 3
mm), binding screws (5 mm × 6 mm) or
flush surface screws (5 mm × 6 mm),
depending on the shape of screw holes
in the bracket.
Screw
Dashboard or console
Factory radio mounting bracket
NOTE
In some types of vehicles, discrepancy may
occur between the unit and the
dashboard. If this happens, use the
supplied frame to fill the gap.
Extend top and bottom of the trim ring
outwards to remove the trim ring. And
then loosen the screws (2 mm × 3 mm) to
remove the mounting sleeve.
•
When reattaching the trim ring, push the
trim ring onto the unit until it clicks. (If
the trim ring is attached upside down,
the trim ring will not fit properly.)
Mounting sleeve
Screw (2 mm × 3 mm)
Trim ring
•
Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver’s
voice.
•
Be sure to turn off (ACC OFF) the product
before connecting the microphone.
•
Depending on the vehicle model, the
microphone cable length may be too
DIN Rear-mount
Removing the unit
Installing the
microphone
